1	1800-0013	1
	Retainer Ring
2	2840-0049	1
	Bearing Cover
2A	6031-0258	1
	Name Plate (Specify Model #)
3	2001-0006	2
	Ball Bearing
4	2112-0008	2
	Buna-N Seal (Standard)
4	2112-0009	2
	Viton Seal (Optional)
5	2210-0019	4
	Hex Head Bolt
6	0200-1200C	1
	Endplate (Cast-Iron) with seal
7	1720-0127	1
	O-ring Gasket for Endplate
8	1005-0006	4
	Super Roller (Standard)
9	0300-1200C	1
	Rotor (Cast Iron) with shaft (Std. Rotation)
9A	0301-1200C	1
	Rotor (Cast Iron) with shaft (Reverse Rotation)
10	0500-1200	1
	Shaft
11	2230-0018	1
	Set Screw
12	0100-1200C	1
	Body (Cast Iron) with seal
13	1610-0005	1
	Key
14	3410-0031	1
	Set Screw Kit
15	1320-0067	1
	1-3/8" 6-spline 540 rpm PTO Adapter (Forged Steel) Includes Kit No. 3410-0031
16	3430-0207	1
	Locking Collar Kit: Includes: (1) Collar and (2) Setscrews
17	3420-0028	1
	Base Kit: Includes: (not shown) (1) Base, (4) Bolts and (4) Lock Washers
Kit	3430-0374
	Parts Kit: Includes:(4) Ref. 8 Super Rollers, (1) O-Ring, (2) Buna-N Seals
Locking Collar Kit No. 3430-0207 For Series 1200 Roller Pumps. This locking collar kit holds the pump driver shaft securely on the tractor PTO shaft. It is designed to increase pump life by reducing pump and PTO shaft wear due to vibration. To install locking collar: 1. Slide collar onto pump driver shaft. 2. Thread the longer set screw through the locking collar and partially through the threaded hole in the pump driver shaft. IMPORTANT: It is necessary to allow a minimum of 1/8" clearance between the locking collar and the pump driver shaft at set screw. 3. Thread the shorter set screw into the other threaded hole in the locking collar. 4. Slide pump driver hub over PTO shaft. Be sure PTO groove is under set screw. 5. Tighten the longer screw very securely with a 3/16" allen wrench. 6. Tighten the shorter set screw very securely with the same wrench. This binds set screw which prevents it from coming loose. 7. NOTE: Locking collar is off-center on the pump driver shaft when properly installed.